Installing the power button with fingerprint reader assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicate the location of the power button and provide a visual representation of the installation procedure.
Steps
1. Align and place power button with fingerprint reader assembly on the system. Adhere the power button with fingerprint
reader assembly on the palm-rest assembly.
2. Place the power button with fingerprint reader bracket on the power button with fingerprint reader assembly.
3. Replace the three (M1.6x2.5) screws that secures the power button with fingerprint reader bracket to the palm-rest
assembly.
4. Gently connect the power button with fingerprint reader FPC cable to the connector on the USH daughter board.
Next steps
1. Install the I/O daughter board.
2. Install the display assembly.
3. Install the heat sink.
4. Install the base cover.
5. Install the SIM card tray.
6. Install the SD card.
7. Exit service mode.
8. Follow the procedure in After working on your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in before working inside your computer.
46
Removing and installing components
To Next Page
Loading...
