NOTE: If battery was disconnected from system board for service, there will be a delay during system boot-up as the
system will undergo RTC battery reset.
Steps
1. Align and place the battery from the left side on the laptop.
2. Replace the single (M1.6x3.5) screw and four (M2x3) screws to secure the battery in place.
3. Route the wireless antenna cables on the routing guides and adhere the adhesive tape.
Next steps
1. Install the Speakers.
2. Install the Base cover.
3. Install the SIM card tray
4. Install the microSD card.
5. Follow the procedure in After working on your computer .
38
Removing and Installing Components
To Next Page
Loading...
