Dell Latitude E4310 - DC-In Connector Service

Back to Contents Page
DC-In Connector
Dell Latitude E4310 Service Manual
Removing the DC-In Connector
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Remove the SIM.
4. Remove the ExpressCard.
5. Remove the SD memory card.
6. Remove the hard drive assembly.
7. Remove the hinge covers.
8. Remove the mini card door.
9. Remove the wireless local area network (WLAN) card.
10. Remove the memory door.
11. Remove the memory.
12. Remove the coin-cell battery.
13. Remove the optical drive.
14. Remove the LED covers.
15. Remove the keyboard.
16. Remove the display assembly.
17. Remove the palm rest.
18. Remove the system board.
19. Disconnect the DC-In connector's cable from the system board.
20. Remove the DC-In connector from the computer.
Replacing the DC-In Connector
To replace the DC-In connector, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.