Dell Latitude E4310 - Removing the Display Bezel; Replacing the Display Bezel

Back to Contents Page
Display Bezel
Dell Latitude E4310 Service Manual
Removing the Display Bezel
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Starting from the bottom, gently pry the display bezel inside out from the display assembly using a plastic scribe.
4. When all the snaps loosen, remove the display bezel from the display assembly.
Replacing the Display Bezel
To replace the display bezel, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.