Dell Latitude E5250 - Installing the Palmrest; Removing the Smartcard Reader Board

Installing the Palmrest
1. Place the palmrest on the computer.
2. Connect the following cables to their connectors on the system board:
a. LED board
b. USH board
c. touchpad board
3. Tighten the screws at the front and back of the computer to secure the palmrest.
4. Install the:
a. keyboard
b. keyboard trim
c. battery
d. base cover
5. Follow the procedures in After Working Inside Your Computer
Removing the SmartCard Reader Board
NOTE: This component is sold separately and is not shipped with the computer.
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
c. memory
d. keyboard trim
e. keyboard
f. palmrest
3. Perform the following steps:
a. Disconnect the SmartCard reader board cable from the USH board [1] [2].
b. Peel the cable to release from the adhesive [3].
17