6. Remove the screws that secure the display assembly [1] and lift the display assembly to remove it
from the computer [2].
Installing the Display Assembly
1. Place the display assembly to align with the screw holders on the computer.
2. Route the WWAN, WLAN, and display cables through their routing channels.
3. Tighten the screws to secure the display assembly to the computer.
4. Connect the WWAN and WLAN cables to their connectors.
5. Connect the display cable to the system board, place the display-cable bracket over the connector,
and tighten the screw to secure the display cable to the computer.
6. Install the:
a. display-hinge brackets
b. palmrest
c. keyboard
29
To Next Page
Loading...
