Installing the LED Board
1. Insert the LED board into its slot on the palmrest.
2. Tighten the screw that secures the LED board to the palmrest.
3. Connect the LED-board cable to its connector on the LED board.
4. Install the:
a. palmrest
b. keyboard
c. keyboard trim
d. battery
e. base cover
5. Follow the procedures in After Working Inside Your Computer.
Removing the Power-Connector Port
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
c. keyboard lattice
d. keyboard
e. palmrest
f. display-hinge cap
g. display assembly
3. Disconnect the power-connector port cable from its connector on the system board.
22
To Next Page
Loading...
