Dell Latitude E5470 - Keyboard Removal and Installation Guide

c. dock frame
3. To remove the power connector port:
a. Remove the screws to release the metal bracket on the power connector port [1].
b. Lift the metal bracket from the computer [2].
c. Disconnect the power connector port cable from the computer [3].
d. Remove the power connector port from the computer [4].
Installing the power connector port
1. Insert the power connector port into the slot on the computer.
2. Place the metal bracket on the power connector port.
3. Tighten the screw to secure the power connector port to the computer.
4. Route the power connector port cable through the routing channels.
5. Connect the power connector port cable to the connector on the system board.
6. Install the:
a. dock frame
b. battery
c. base cover
7. Follow the procedure in After working inside your computer.
Keyboard lattice and Keyboard
Removing the keyboard
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. Disconnect the keyboard cables from the connectors on the touchpad board [1, 2].
22
Disassembly and reassembly