a. Disconnect the coin cell battery cable from the connector on the system board [1].
b. Lift the coin cell battery to release it from the adhesive and remove it from the system board [2].
Installing the coin cell battery
1. Place the coin cell battery into the slot on the system board.
2. Connect the coin cell battery cable to the connector on the system board.
3. Install the:
a. power connector port
b. WLAN
c. heat sink assembly
d. WWAN
e. dock frame
f. hard drive assembly or M.2 SSD or PCIe SSD
g. keyboard
h. memory module
i. dock frame
j. hard drive assemblyor M.2 SSD or PCIe SSD
k. battery
l. base cover
4. Follow the procedure in After working inside your computer.
Palm rest
Removing the palmrest
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. SIM card
b. base cover
c. battery
d. memory
e. hard drive assembly or M.2 SSD or PCIe SSD
f. keyboard
g. WLAN
Disassembly and reassembly
33
To Next Page
Loading...
