Dell Networking 7048 - Page 24

22 System Firmware Version 5.1.0.1
Release 5.0.1.3
http[s] authentication
against RADIUS only
allows privilege level 1
access
HTTPS authentication through
RADIUS grants only read-only
access.
parse RADIUS server response
properly
All 5.0 supported
platforms
SNMP v1/2 community
manager address no longer
functions with network
address.
When a subnet IP is set as
SNMP community IP address
then snmp requests from hosts
of that subnet are not accepted
on the box.
Get the mask from the
community IP address
configured and set it instead of
the hard coded value.
All 5.0 supported
platforms
Switch service tag not
displayed by “show system
id” command
Switch service tag not displayed
with “show system id”
command
Added retry to get the Service
Tag value
M8024-k, M8024, M6348
CLI commands are not
authorized after Password
Recovery
Enabling password recovery will
not allow the user to run CLI
commands on the serial console.
Fixed the issue to enable
commands from serial console
also
All 5.0 supported
platforms
LINK UP on all interfaces
during POST,
Links are UP and flapping
during power reset and reloads.
Changed the CPLD and reset
logic
PC8024 and PC81xx
FCoE -M8024-k setting
TSA map to link strict and
assigning bandwidth
allocation to TC
In the CEE mode there is no
way to specify the TSA mode in
the ETS TLV
Check if any weight is
configured for the TCGs, if so
set the mode to ETS.
Platforms running DCBX
and including ETS
Switch GUI forcing 100Mb
speed on External ports
when cloning port
configurations
Switch GUI set all external ports
to 100Mb speed when cloning
port configurations.
Corrected port speed
processing from WEB
M6348
PowerConnect
M6348/General port GUI
issue
Vlan membership information
on web is displayed and applied
incorrectly
Javascript fixed to pick correct
enum values
M6348
M6348 - service tag not
displayed in GUI
Service tag shows up as none on
GUI
Synchronization issue fixed to
retry and get the tag
information
M6348
email addresses with
underscore "_" are rejected
A valid email id with an
underscore cannot be used
Underscore is now considered
valid character
All 5.0 supported
platforms
phone port configuration
macro incomplete
The macro never returns and
appears to hang
Fixed the issue and return error
All 5.0 supported
platforms
Summary
User Impact
Resolution
Affected Platforms
Re-enable Auto
Negotiation
using GUI
doesn't work
properly
The Auto Negotiation can't be enabled back
on "Port Configuration->Show All" page
once it has been disabled.
Corrected error in Port
Configuration page.
All 5.0 supported
platforms