Dell Networking 7048 - Page 25

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.0.1 Page 23
Release 5.0.0.4
VLAN ACL
blocks traffic
across stack
members
ACL prevented traffic from reaching
destination
Prevented VLAN ACL from
being applied to stack ports.
All 5.0 supported
platforms
Power supply
logging
Power Supply messages are only sent to the
log file.
Elevated failure messages to
ERROR severity
All 5.0 supported
platforms
'no ipv4 or ipv6
address found in
response for
request id' error
'no ipv4 or ipv6 address found in response
for request id' error message flooding the
switch
Corrected problem that was
causing extra error messages to
be displayed.
All 5.0 supported
platforms
phone port
configuration
macro
incomplete
The phone port is missing some needed
commands
Added missing commands to
the pone port macro.
All 5.0 supported
platforms
web session
timeout
Web session would timeout regardless of
the timeout setting
Corrected the hard timeout to
be one hour.
All 5.0 supported
platforms
RX Equalizer
setting on
Stacking ports.
RX Equalizer was not set on the stacking
port which caused stacking errors to be
reported.
Added RX Equalizer value.
All PC70XX Switches
interface speed
options
Invalid speed options message is not clear
Changed the message reported
when an invalid speed option
is input.
All 5.0 supported
platforms
Change PoE
Disconnect
Type to DC
disconnect
PoE controller Disconnect Type was
changed to DC Disconnect.
PoE controller Disconnect
Type was changed to DC
Disconnect.
PC7024P
PC7048P
stacking with
extension
modules
Stacking with redundant stack rings caused
packet flooding on the stacking links.
Corrected problem with stack
link queuing.
All 5.0 supported
platforms
DHCP Req pkts
are not being
forwarded to
Voice VLAN
Component
When using Avaya phone on a switch
running dot1x, the phone will NOT get
authenticated and thus will not boot
Corrected DHCP forwarding
problem.
All 5.0 supported
platforms
Netlogic
memory and B0
CPU support
Netlogic memory and B0 CPU support Added support for Netlogic
memory and B0 CPU.
PC8132
PC8132F
PC8164
PC8164F
Summary
User Impact
Resolution
Affected Platforms
OpenManage UI
does not accept
blank space
character for
port description
Port description does not accept space
Correction the port description
validation to accept spaces.
All 4.2 supported
platforms