Dell Networking 7048 - Page 37

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.0.1 Page 35
No message
logged for "Max
number of SSH
login sessions
exceeded"
The switch does not log an error message
when the maximum number of SSH
sessions has been exceeded.
The switch does accept 5 SSH sessions
normally, when the 6th session connection
is attempted via SSH, the connection is
refused, but no error message is logged.
A Log message "Unable to
find a free connection.
Exceeded the maximum
number of allowed
connections." has been added.
All 4.2 supported
platforms
CLI command
"show ipv6
interface" does
not paginate
correctly
The CLI command "show ipv6 interface"
does not paginate correctly when a large
number of interfaces/addresses are
configured.
Pagination mechanism
corrected.
All 4.2 supported
platforms
2nd and 4th
block of copper
ports 5-8 and
13-16 think they
are fiber ports,
possible
problems
Ports report to be fiber ports and not copper
ports.
Corrected error checking logic
to correctly select fiber ports
for fiber diags and copper ports
for copper diags.
PC8024/PC8024F
WebGui Secure
Shell SSH
Remote Access
On the WebGui under Management
Security,
Secure HTTP, Secure Shell does not work
on the Web UI
Issue is corrected
All 4.2 supported
platforms
Web UI MSTP
Instance pull
down menu
displays 4k
MSTIs
In the "MSTP Interface Settings" page of
the Web UI, the Instance pull down menu
has a range of 1-4094 MSTIs.
Issue is corrected
All 4.2 supported
platforms
Flowcontrol
negotiation
issues with
10GBase-T
module
Flowcontrol negotiation issues between
6200 and 8024/8024F
Driver update applied.
PC8024/PC8024F
PC8024 - GUI -
Under Port
Configuration
page get error
on 10GB ports
when you
change any
setting
When you change the port setting, for
example the duplex settings or description,
from the GUI under switching -> Ports ->
Port Configuration you will get outputs
error when changing port settings on 10G
ports. The popup says 10G speed is invalid.
Error message attached. This is a problem
with code version 4.1.0.6 under the GUI no
problem when using the command prompt.
Erroneous pop-up message
removed.
All 4.2 supported
platforms
Unable to config
secure ssh from
web interface.
error
'sshcfg_load
start' missing
pops up
Unable to configure Secure Shell from web
interface. Error pops up.
Corrected web page
All 4.2 supported
platforms
Web interface
fails to provide
an iSCSI web
page when
selecting the
iSCSI item.
The web page for iSCSI fails to open when
selected with OpenManage.
.
Corrected web index page
All 4.2 supported
platforms