Dell Networking 7048 - Page 45

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.0.1 Page 43
Summary User Impact Resolution Affected
Platforms
Need to change message on
console when try to
downgrade anything below
4.1.0.19 release for new DDR
If a switch contains new DDR,
downgrading to 4.1.0.19 is not allowed.
Modified the downgrade
message.
PCM8024
PCM8024-k
(with new
DDR)
Release 4.1.0.19
Summary User Impact Resolution Affected
Platforms
Combo ports flapping when
fiber port connected to certain
other vendor switches
Users unable to reliably operate over
combo ports
Corrected combo port
flapping issue with new
PHY firmware. Added new
media-type command to
configure the preference on
a combo port
PC8024
PC8024F
New M8024/M8024-k cards
have different memory parts
requiring changes to DDR
timings
User unable to downgrade to earlier
version of firmware
No resolution. Newer IOMs
do not support earlier
versions of firmware.
PCM8024
PCM8024-k
10GBaseT ports do not come
up
Unable to use 10GBaseT ports on
PC7048R-RA
Corrected internal
addressing of port. Ports
now come up properly.
PC7048R-RA
Switch crashes when
executing “show interfaces
detail te1/2/1” command with
no space between “te” and the
unit/slot/port identifier
Service interruption due to crash Issue has been corrected. M8024
M6220
M6348
M8024-k
OOB Default Gateway does
not save when using CLI setup
wizard
There was no way to configure the
gateway on Out-Of-Band interface.
Add functionality for
configuring gateway on
Out-Of-Band interface.
All Platforms
Upgrades to 4.1.0.6 are
causing network outages. The
wizard from 4.1.0.6 fails to
setup interfaces
Ports on some devices will not attach. Corrected the Configuration
Wizard to properly apply
the configuration to all
ports.
All Platforms
The combo port is not coming
up after performing repeated
plug-out and plug-in.
The fibers port associated with Fiber /
RJ45 combo ports may flap or not link up
with certain other switches.
Add commands to allow
operator to prefer or force
RJ45 or SFP port selection
on combo ports.
PC8024F/
PC8024
Line "no passive-interface
Vl32" in startup-config does
not get loaded on startup.
The "no passive-interface Vl32"
configuration does not get loaded from the
startup-config on startup.
Corrected the loading of the
"no passive-interface Vl32"
configuration.
All Platforms
Unable to configure Secure
Shell from web interface.
Proper web page operation is prevented. Web page has been
corrected.
All Platforms
OpenManage web interface
fails to provide an iSCSI web
page when selecting the iSCSI
item.
The web page for iSCSI fails to open when
selected with OpenManage.
Web page has been
corrected.
All Platforms
Wrong information for current
link status in port
configuration page.
Incorrect stacking link status is presented
in the Web page.
Web page output has been
corrected.
PCM6220