28 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
In the
Edit
column, select the check box to allow editing on the ports to be used for stacking. Then use
the drop-down menu in the
Configured Stack-mode
column to put each port in stack mode. The
Configured Stack Mode is now
Stack
, but the Running Stack-mode does not show Stack until the switch is
reloaded, as instructed below.
Save the configuration to the Startup-Configuration using the System > File Management > Copy Files
page.
After saving the configuration, remove power from the switch.
To Next Page
Loading...
