Dell Networking N4032 User Manual

55 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
3 Managing the standby unit
If the Master unit fails or is taken offline, a Standby unit automatically takes place as Master. During this
time there is no more than a 50 ms interruption in unicast connectivity.
The commands below are used to manage your Standy unit.
3.1.1 Command-line interface method
To find out which unit is currently in Standby status, run the show switch command.
console#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Status Status Model ID Model ID Status Version
--- ---------- --------- ------------- ------------- ------------- -------
1 Mgmt Sw N4032 N4032 OK 6.0.1.3
2 Stack Mbr Oper Stby N4064 N4064 OK 6.0.1.3
3 Stack Mbr N4032F N4032F OK 6.0.1.3
The Standby Status column shows which unit is in Standby mode. There are two standby modes: Oper
Stby and Cfg Stby . Oper Stby is selected automatically by the Master during stack creation. If the
administrator decides to select a different unit to be Standby, then it is labeled Cfg Stby. Both Standby
modes work identically.
In this example, unit 2 is the stack standby for the Master unit. To change the standby to a different unit,
use the standby x command. Verify the change with the show switch command.
console(config-stack)#standby 3
console#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Status Status Model ID Model ID Status Version
--- ---------- --------- ------------- ------------- ----------- -------
1 Mgmt Sw N4032 N4032 OK 6.0.1.3
2 Stack Mbr N4064 N4064 OK 6.0.1.3
3 Stack Mbr Oper Stby N4032F N4032F OK 6.0.1.3
This method cannot be used to assign the current Stack Master to the Standby role and results in an error.
In the event there is a need to change the role of the Master or make the Standby the Master, use the
initiate failover command from the Command Line Interface. This command results in a warm
restart of the stack Master, triggering the Standby unit to take over as a new Master switch.

Dell Networking N4032 Specifications

General

Rack Units	1U
Layer	Layer 3
Manageable	Yes
Stackable	Yes
MAC Address Table Size	32, 000 entries
Jumbo Frame Support	Yes
Jumbo Frame Size	9216 bytes
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C (32°F to 113°F)
Uplink Ports	8 x 10 Gigabit Ethernet 10GBASE-T
Power Supply	Dual, hot-swappable
Operating Humidity	10% to 90% non-condensing