Dell Networking N4032 User Manual

32 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F
TFTP code transfer starting
12487236 bytes transferred...
File contents are valid. Copying file to flash...
Attempting to send the STK file to other units in the stack…
File transfer operation completed successfully.
Note: This procedure may take a few minutes longer than updating a single, non-stacked switch.
Perform another show version command to see the new firmware has been downloaded to all members
of the stack. Notice the firmware was only copied into the backup image for each member.
console#show version
Image Descriptions
active :
backup :
Images currently available on Flash
unit active backup current-active next-active
----- ------------ ------------ ----------------- -----------------
1 6.0.0.8 6.0.1.3 6.0.0.8 6.0.0.8
2 6.0.0.8 6.0.1.3 6.0.0.8 6.0.0.8
3 6.0.0.8 6.0.1.3 6.0.0.8 6.0.0.8
4 6.0.0.8 6.0.1.3 6.0.0.8 6.0.0.8
The next step is to activate the image that contains the new firmware by using the boot system backup
command.
console#boot system backup
Activating image backup ..
console#show version
Image Descriptions
active :
backup :
Images currently available on Flash
unit active backup current-active next-active
----- ------------ ------------ ----------------- -----------------
1 6.0.0.8 6.0.1.3 6.0.0.8 6.0.1.3
2 6.0.0.8 6.0.1.3 6.0.0.8 6.0.1.3

Dell Networking N4032 Specifications

General

Rack Units	1U
Layer	Layer 3
Manageable	Yes
Stackable	Yes
MAC Address Table Size	32, 000 entries
Jumbo Frame Support	Yes
Jumbo Frame Size	9216 bytes
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C (32°F to 113°F)
Uplink Ports	8 x 10 Gigabit Ethernet 10GBASE-T
Power Supply	Dual, hot-swappable
Operating Humidity	10% to 90% non-condensing