Dell OptiPlex 3070 Small Form Factor - Installing the M.2 Pcie SSD

3. To remove the M.2 PCIe SSD:
a) Remove the single (M2x3.5) screw that secures the M.2 PCIe SSD to the system board [1].
b) Lift and pull out the PCIe SSD from its connector on the system board [2].
c) Remove the SSD thermal pad [3].
Installing the M.2 PCIe SSD
NOTE:
The instructions are applicable to M.2 SATA SSD also.
1. Place the SSD thermal pad into the slot on the system board [1] .
2. Insert the M.2 PCIe SSD to the connector on the system board [2].
3. Replace the single (M2x3.5) screw that secures the M.2 PCIe SSD to the system board [3].
100
Removing and installing components