Dell OptiPlex 3070 Small Form Factor User Manual

Installing the system board
1. Hold the system board by its edges, and align it towards the back of the system.
2. Lower the system board into the system chassis until the connectors at the back of the system board align with the slots on the
chassis, and the screw holes on the system board align with the standoffs on the system chassis
[1,2].
3. Replace the single screw used as a mounting point for M.2 SSD drive, the standoff single (#6-32) screw and the 5 screws that secure
the system board to the system [1, 2, 3].
Removing and installing components
63

Dell OptiPlex 3070 Small Form Factor Specifications

General

Brand	Dell
Model	OptiPlex 3070 Small Form Factor
Category	Desktop
Language	English