Dell OptiPlex 320 - Page 101

Back to Contents Page
 I/O Panel
Dell™OptiPlex™320User'sGuide

Removing the I/O Panel



1. Follow the procedures in Before You Begin.

2. Remove the screw that secures the I/O panel.

3. Disconnect all of the cables from the I/O panel, and remove the panel from the computer.

Replacing the I/O Panel

1. To replace the I/O panel, follow the removal procedure in the reverse order.
Back to Contents Page

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTE: Note the routing of all cables as you remove them so that you can re-route them correctly when installing the new I/O panel.
NOTICE: When sliding the I/O panel out of the computer, be extremely careful. Carelessness my result in damage to the cable connectors and the cable
routing clips.
1
securing screw
2
I/O panel
3
I/O cable connector
NOTE: Use the guides on the I/O panel bracket to help position the I/O panel in place, and use the notch on the I/O panel bracket to help seat the
panel.