Installing system fan
1 Insert the grommets into the slots on the back of the computer.
2 Hold the system fan with the cable facing the bottom of the computer.
3 Align the grooves of the system fan with the grommets on the chassis wall.
4 Pass the grommets through the corresponding grooves on the system fan.
5 Stretch the grommets and slide the system fan toward the computer until it locks into place.
NOTE: Install the lower two grommets rst.
6 Secure the intrusion switch cable to the system fan with an adhesive tape.
7 Connect the system fan cable to the connector on the system board.
8 Close the front panel door.
9 Install the:
a intrusion switch
b bezel
c cover
10 Follow the procedure in After working inside your computer.
System board
Removing system board
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a cover
b bezel
3 Open the front panel door.
4 Remove the:
a heat sink assembly
b processor
c expansion card
d optional M.2 PCIe SSD
e SD card reader
f memory module
g VGA daughter board
5 Disconnect the optical drive and hard drive cables [1,2] from the connectors on the system board.
40
Removing and installing components
To Next Page
Loading...
