2. Place the WLAN card bracket to secure the antenna cables.
3. Align the notch on the WLAN card with the tab on the WLAN card slot. Insert the WLAN card into the connector on the
system board.
4. Replace the (M2x3.5) screw to secure the WLAN card bracket to the WLAN card.
5. Align and place the WWAN-card shielding cover, press to fit it firmly to cover the WWAN card.
Next steps
1. Install the graphics card.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Fan assembly
Removing the fan assembly-Discrete configuration
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the graphics card
About this task
The following images indicate the location of the fan assembly and provide a visual representation of the removal procedure.
24
Removing and installing components
To Next Page
Loading...
