Steps
1. Align and place the fan assembly on the system board.
2. Replace the three (M3x25) screws that secures the fan assembly to the system board.
3. Connect the fan cable to the connector on the system board.
Next steps
1. Install the graphics card.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the graphics card
NOTE:
Removing the coin-cell battery resets the BIOS setup program settings to default. It is recommended that you note
the BIOS setup program settings before removing the coin-cell battery.
26 Removing and installing components
To Next Page
Loading...
