4. Slide the fan assembly into its slot on the computer chassis and release the tabs.
NOTE: Ensure that the tabs are snapped into position on the heat sink.
Next steps
1. Install the speaker.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Memory
Removing the memory module
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the speaker.
4. Remove the fan.
About this task
The DDR5 thermal pad is required for the following memory configurations:
1. 32 GB: 2 x 16 GB, DDR5, 5600 MT/s, SoDIMM, dual-channel
2. 64 GB: 2 x 32 GB, DDR5, 4800 MT/s, SoDIMM, dual-channel
The following image(s) indicate the location of the memory and provides a visual representation of the removal procedure.
Figure 32. Removing the memory module
Steps
1. Carefully spread apart the securing-clips on each end of the memory-module slot (DIMM1 or DIMM2).
2. Grasp the memory module near the securing clip, and then gently ease the memory module out of the memory-module slot.
Removing and installing Customer Replaceable Units (CRUs)
55
To Next Page
Loading...
