Figure 38. Removing the optional Type-C module
Steps
1. Remove the two (M2x3) screws that secure the optional Type-C module.
2. Slide the optional Type-C module away from its slot on the chassis.
3. Flip over the optional Type-C module and hold it in place over the system board.
4. Disconnect the Type-C DisplayPort cable from its connector (VIDEO) on the system board.
5. Disconnect the Type-C USB cable from its connector (TYPE-C) on the system board.
6. Disconnect the Type-C signal cable from its connector (SIGNAL) on the system board.
7. Disconnect the Type-C power cable from its connector (TOPPOWER) on the system board.
8. Remove the optional Type-C module from the computer.
Installing the optional Type-C module
CAUTION: The information in this section is intended for authorized service technicians only.
62 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
