Dell P93G - Chapter 24: Removing the I;O Board; Prerequisites; Procedure

Removing the I/O board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Remove the base cover.
Procedure
1. Peel off the tape that secures the I/O-board cable to the palm-rest and keyboard assembly.
2. Open the latch, and disconnect the I/O-board cable from the I/O board.
3. Remove the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
4. Lift the I/O board off the palm-rest and keyboard assembly.
24
Removing the I/O board 47