Replacing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1. Slide the camera cable into the connector one the camera module and adhere the tape that secures the camera cable to the
camera module.
2. Using the alignment post, adhere the camera module on the display panel.
Post-requisites
1. Follow the procedure from step 3 to step 5 in "Replacing the display back-cover and antenna assembly".
2. Replace the display assembly.
3. Replace the wireless card.
4. Replace the battery.
5. Replace the base cover.
37
Replacing the camera 65
To Next Page
Loading...
