56
Figure 6-9. File Download (PowerConnect 2748 Switch Configuration)
Firmware Download —
The Firmware file is downloaded. If
Firmware Download
is selected, the
Configuration Download
fields are grayed out.
Configuration Download —
The Configuration file is downloaded. If
Configuration Download
is
selected, the
Firmware Download
fields are grayed out.
Download via TFTP
— Enables initiating an image download via the TFTP server.
Download via HTTP
— Enables initiating an image download via the HTTP protocol.
Firmware Download
Server IP Address —
The Server IP Address from which the firmware files are downloaded.
Source File Name (1-159 Characters)—
Indicates the file to be downloaded.
Destination File Name —
The destination file type to which the file is downloaded. The possible
field values are:
Software Image —
Downloads the image file.
Boot Code —
Downloads the Boot file
NOTE: The image file overwrites the non-active image. It is recommended to designate that the
nonactive image will become the active image after reset, and then to reset the device following the
download. During the image file download, a dialog box opens which displays the download progress.
The window closes automatically when the download is complete.
To Next Page
Loading...
