Tower-to-Rack and Rack-to-Tower Conversion Guide 9
• Installing the system in the rack
• Installing the cable-management arm
• Routing cables
• Installing the rack bezel
• Installing the rack doors
Removing the Bezel, Metal Feet, and Cover
1
To remove the bezel, orient the system as shown in Figure 1-2 and perform the following
steps:
a
Unlock the keylock. See Figure 1-2.
b
Rotate the keylock end of the bezel away from the front panel.
c
Unhook the other end of the bezel and pull the bezel away from the system.
Y1001bk0.book Page 9 Thursday, July 8, 2004 4:32 PM
To Next Page
Loading...
