Tower-to-Rack and Rack-to-Tower Conversion Guide 23
Figure 1-12. Removing the System
Installing the Tower Trim Panel
1
Lay the system on its cover as shown in Figure 1-13.
2
Position the tower trim panel with the back end extending 12.7 millimeters (0.5-inch) beyond
the back of the chassis. See Figure 1-13
3
Slide the trim panel toward the front panel until it stops.
4
Using a #2 Phillips screwdriver or 1/4-inch nut driver, install the two screws that secure the
trim panel to the back of the chassis.
5
Using a #2 Phillips screwdriver or 1/4-inch nut driver, install the three screws that secure the
trim panel to the side of the chassis.
system locking mechanism
system locking
mechanism release button
Y1001bk0.book Page 23 Thursday, July 8, 2004 4:32 PM
To Next Page
Loading...
