16 Tower-to-Rack and Rack-to-Tower Conversion Guide
www.dell.com | support.dell.com
Removing the Trim Panel
1
Remove the trim panel.
a
Lay the system on its cover as shown in Figure 1-7.
b
Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the
side of the trim panel. See Figure 1-7.
c
Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the two screws from the
back of the system.
d
Slide the trim panel backward and then remove the trim panel from the chassis.
Figure 1-7. Removing the Trim Panel
2
Install the six shoulder nuts as shown in Figure 1-8.
NOTE: Ensure that the shoulder nuts are tightened so that the shoulder of the nut is tight against
the side.
The system is ready to install in the rack.
hex-head Phillips
screws (3)
hex-head Phillips
screws (2)
Y1001bk0.book Page 16 Thursday, July 8, 2004 4:32 PM
To Next Page
Loading...
