106 Installing System Components
1
Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2
Open the system. See "Opening the System" on page 76.
3
Locate the ISCSI KEY connector on the system board. See Figure 6-1.
4
Insert the NIC hardware key into the connector on the board. See
Figure 3-15.
Figure 3-15. Removing and Installing a NIC Hardware Key
5
Close the system. See "Closing the System" on page 77.
6
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1 NIC hardware key 2 ISCSI KEY connector
book.book Page 106 Wednesday, February 17, 2010 6:17 PM
To Next Page
Loading...
