Dell PowerEdge E05S - Installing the Cooling Shroud

Installing System Components 89
Figure 3-9. Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
NOTE: For proper alignment of the cooling shroud in the system, ensure that the
cables inside the system are routed along the chassis wall. See Figure 3-10.
1 Lower the cooling shroud into the system and align the cooling shroud
tabs with the slots on the system. See Figure 3-9.
2 Insert the RAID battery into the battery carrier in the cooling shroud. See
"Installing the RAID Battery" on page 119.
3 Close the system. See "Opening and Closing the System" on page 76.
1 cooling shroud 2 RAID battery carrier
3 shroud tabs (6) 4 touch points (2)
1
3
2
4
book.book Page 89 Wednesday, February 17, 2010 6:17 PM