Dell PowerEdge E05S - Installing a Hard-Drive Blank

Installing System Components 79
Figure 3-4. Removing and Installing a Hard-Drive Blank
Installing a Hard-Drive Blank
1 If installed, remove the front bezel . See "Removing the Front Bezel" on
page 75.
2 Insert the drive blank into the drive bay until the release button clicks into
place.
3 If applicable, replace the front bezel. See "Installing the Front Bezel" on
page 75.
1 hard-drive blank 2 release button
1
2
book.book Page 79 Wednesday, February 17, 2010 6:17 PM