126 Installing System Components
CAUTION: Never remove the heat sink from a processor unless you intend to
remove the processor. The heat sink is necessary to maintain proper thermal
conditions.
7
Using a #2 Phillips screwdriver, loosen the heat-sink retention screws. See
Figure 3-23.
8
Gently lift the heat sink off the processor and keep it aside with the
thermal grease side facing up.
Figure 3-23. Removing and Installing the Heat Sink
1 heat sink 2 slot on system board
book.book Page 126 Wednesday, February 17, 2010 6:17 PM
To Next Page
Loading...
