Installing System Components 91
Figure 3-10. Sliding the Front-Chassis Assembly
To slide the front-chassis assembly back into the locked position:
1
Slide the assembly inside until it snaps into position.
NOTE: For proper system cooling, ensure that the cables inside the system do
not obstruct airflow.
2
Route the SAS and SATA cables along the chassis wall. See Figure 3-10.
1 front-chassis assembly 2 control panel cable
3 USB cable 4 SAS backplane power cable
5 cable clamp 6 release tabs (2)
7 SATA cable 8 SAS cables (2)
book.book Page 91 Wednesday, February 17, 2010 6:17 PM
To Next Page
Loading...
