EasyManuals Logo

Dell PowerEdge M420 User Manual

Dell PowerEdge M420
1682 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1014 background imageLoading...
Page #1014 background image
1014 Loopback Interface Commands
User Guidelines
This command has no user guidelines.
Example
The following example enters the Interface Loopback 1 configuration mode.
console(config)#interface loopback 1
console(config-if-loopback0)#ip address 192.168.22.1
255.255.255.255
console(config-if-loopback0)#exit
console(config)#ex
console#ping 192.168.22.1
Pinging 192.168.22.1 with 0 bytes of data:
Reply From 192.168.22.1: icmp_seq = 0. time <10 msec.
Reply From 192.168.22.1: icmp_seq = 1. time <10 msec.
Reply From 192.168.22.1: icmp_seq = 2. time <10 msec.
Reply From 192.168.22.1: icmp_seq = 3. time <10 msec.
show interfaces loopback
Use the show interfaces loopback command in Privileged EXEC mode to
display information about one or all configured loopback interfaces.
Syntax
show interfaces loopback [
loopback-id
]
•
loopback-id
— Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
2CSPC4.XModular-SWUM200.book Page 1014 Thursday, March 10, 2011 11:18 AM

Table of Contents

Other manuals for Dell PowerEdge M420

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerEdge M420 and is the answer not in the manual?

Dell PowerEdge M420 Specifications

General IconGeneral
BrandDell
ModelPowerEdge M420
CategoryServer
LanguageEnglish

Related product manuals