412 Ethernet CFM Commands
Command Mode
Interface Configuration
User Guidelines
This command has no user guidelines.
Example
The following example creates a maintenance endpoint at level 1 with mpid
1010 on vlan 10.
console(config-if-Gi1/0/3)#ethernet cfm mep level 1
direction up mpid 1010 vlan 10
ethernet cfm mep enable
Use the ethernet cfm mep enable command in Interface Configuration mode
to enable a MEP at the specified level and direction. Use the no form of the
command to disable the MEP.
Syntax
ethernet cfm mep enable level
0-7
vlan
1-4093
mpid
1-8191
Parameter Description
Default Configuration
No MEPs are preconfigured.
Command Mode
Interface Configuration
Parameter Description
level Maintenance association level
mpid Maintenance entity identifier
vlan VLAN on which the MEP operates
2CSPC4.XModular-SWUM200.book Page 412 Thursday, March 10, 2011 11:18 AM
To Next Page
Loading...
Need help?
General