566 Port Aggregator Commands
Example
console(config)#port-aggregator group 1
console(config-aggregator-1)#add ethernet 1/g1
console(config-aggregator-1)#
duplex
Use the duplex command in port aggregator configuration mode to configure
the full/half duplex operation of all member ports in the aggregator
group/zone. To restore the default, use the no form of this command.
Syntax
duplex
[half | full]
no duplex
•
half
— Force half-duplex operation.
•
full
— Force full-duplex operation.
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 1
console(config-aggregator-1)#speed 1000
console(config-aggregator-1)#
2CSPC4.XModular-SWUM200.book Page 566 Thursday, March 10, 2011 11:18 AM
To Next Page
Loading...
Need help?
General