970 IPv6 Routing Commands
ipv6 mld query-max-response-time
The ipv6 mld query-max-response-time command sets MLD query
maximum response time for the interface. This value is used in assigning the
maximum response time in the query messages that are sent on that
interface. Use the “no” form of this command to set the maximum query
response time to the default.
Syntax
ipv6 mld query-max-response-time
query-max-response-time
no ipv6 mld query-max-response-time
•
query-max-response-time
— Maximum query response time (Range:
1–65535 milliseconds).
Default Configuration
The default query maximum response time is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld query-max-response-
time 4500
ipv6 mld router
The ipv6 mld router command is used to enable MLD in the router in global
configuration mode and for a specific interface in interface configuration
mode. Use the “no” form of this command to disable MLD.
Syntax
ipv6 mld router
2CSPC4.XModular-SWUM200.book Page 970 Thursday, March 10, 2011 11:18 AM
To Next Page
Loading...
Need help?
General