Steps
1. Align the screw holes on the hard drive or SSD cage with the screw holes on the chassis.
2. Lower the hard drive or SSD cage into the chassis until it is seated firmly in place.
3. Install the four screws to secure the hard drive or SSD cage to the chassis.
Figure 55. Installing a hard drive or SSD cage
1.
standoff (4) 2. hard drive or SSD cage
3. screw (2) 4. screw hole (2)
Next steps
1. Install the hard drive or SSD backplane.
2. Install the hard drive or SSDs.
3. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Removing the hard drive or SSD cage on page 103
Installing the hard drive or SSD backplane on page 107
After working inside your system on page 52
Installing a hard drive or SSD on page 95
Installing and removing server module components
105
To Next Page
Loading...
