Figure 27. Removing the optional IDSDM card
1.
IDSDM card 2. screw (2)
3. SD card slot bracket 4. PCIe mezzanine card support bracket
5. IDSDM card connector on the system board 6. standoff (2)
Next steps
1. Install the IDSDM card.
2. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Installing the optional IDSDM card on page 77
Before working inside your system on page 51
Replacing the internal USB key on page 75
Replacing an SD card on page 73
After working inside your system on page 52
Installing the optional IDSDM card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other components inside the system.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
Installing and removing server module components
77
To Next Page
Loading...
