Initial system setup and configuration
Topics:
• Setting up your system
• iDRAC configuration
• Options to install the operating system
Setting up your system
Complete the following steps to set up your system:
Steps
1. Unpack the server module.
2. Remove the I/O connector cover from the server module connectors.
CAUTION: While installing the server module, ensure that it is properly aligned with the slot on the enclosure to
prevent damage to the server module connectors.
3. Install the server module in the enclosure.
4. Turn on the enclosure.
NOTE: Wait for the chassis to initialize before you press the power button.
5. Turn on the server module by pressing the power button on the server module.
Alternatively, you can also turn on the server module by using:
• The server module iDRAC. For more information, see the Log in to iDRAC section.
• The enclosure Chassis Management Controller (CMC), after the server module iDRAC is configured on the CMC. For more
information, see the CMC User’s Guide at Dell.com/idracmanuals.
Related References
Log in to iDRAC on page 22
Related tasks
Installing a server module on page 54
iDRAC configuration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve the
overall availability of Dell EMC systems. iDRAC alerts administrators to system issues, helps them perform remote system management,
and reduces the need for physical access to the system.
Options to set up iDRAC IP address
You must configure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC.
You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
utility
See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
4
Initial system setup and configuration 21
To Next Page
Loading...
