Figure 59. Installing the 1.8-inch (x4) SSD backplane
1.
hard drive or SSD backplane 2. hard drive or SSD backplane cable
3. release latch (2) 4. guide pin (3)
5. retention screw on the backplane cable connector (2) 6. connector on system board
Next steps
1. Install the hard drives or SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Removing a hard drive or SSD on page 94
Removing the hard drive or SSD backplane on page 106
After working inside your system on page 52
Installing the hard drive or SSD cage on page 104
Installing a hard drive or SSD on page 95
Storage controller card
Your system includes a dedicated expansion card slot on the server module system board for a storage controller card that provides the
integrated storage subsystem for your system’s hard drives. The storage controller card supports SAS HDDs, SATA HDDs, and PCIe
SSDs.
NOTE: The storage controller card is located underneath the hard drive bays.
Installing and removing server module components 109
To Next Page
Loading...
