Figure 57. Removing the 1.8-inch (x4) SSD backplane
1.
hard drive or SSD backplane 2. hard drive or SSD backplane cable
3. release latch (2) 4. guide pin (3)
5. retention screw on the backplane cable connector (2) 6. connector on system board
Next steps
1. Install the hard drive or SSD backplane.
2. Install the hard drive or SSD.
3. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Installing the hard drive or SSD backplane on page 107
Removing a hard drive or SSD on page 94
Removing the hard drive or SSD cage on page 103
After working inside your system on page 52
Installing the hard drive or SSD backplane
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
NOTE: You must remove the hard drive or SSD backplane to replace a faulty hard drive or SSD backplane or service
other components inside the system.
Installing and removing server module components 107
To Next Page
Loading...
