Figure 62. Removing the system board
1.
hex nut screw (4) 2. system board
3. screw (10) 4. system board handle
Next steps
1. Install the system board.
2. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Installing the system board on page 115
After working inside your system on page 52
Removing a heat sink on page 86
Removing memory modules on page 64
Removing the cooling shroud on page 66
Removing a hard drive or SSD on page 94
Removing the hard drive or SSD backplane on page 106
114
Installing and removing server module components
To Next Page
Loading...
