Figure 37. Installing and removing a processor
1.
socket-release lever 1 2. pin–1 corner of the processor
3. processor 4. slot (4)
5. processor shield 6. socket-release lever 2
7. processor socket 8. tab (4)
Example
Enter an example that illustrates the current task (optional).
Next steps
1. Replace the processor(s).
2. Install the heat sink.
3. Reinstall the cooling shroud.
4. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Installing the cooling shroud on page 67
Removing a heat sink on page 86
Installing a processor on page 90
Installing a heat sink on page 91
Removing the cooling shroud on page 66
After working inside your system on page 52
Installing and removing server module components
89
To Next Page
Loading...
