Figure 103. Removing the LOM filler bracket
2. Install the LOM riser bracket.
a. Insert and slide the LOM riser bracket into the slot on the chassis.
b. Using a Phillips #2 screwdriver, secure the bracket to the chassis with a screw.
Figure 104. Installing the LOM riser bracket
3. Slide the LOM riser card towards the rear of the system to engage the ports from the slot on the chassis.
4. Connect the LOM riser card to the connector on the system board and push the card until the blue retention clip locks in
place.
5. Using a Phillips #2 screwdriver, tighten the screws to secure the LOM card riser to the system..
100
Installing and removing system components
To Next Page
Loading...
