Dell PowerEdge R7515 MY077 - Removing the expansion card riser

Table 20. Riser configurations: Riser 1B – CPU (continued)
Card type Slot priority Maximum number of cards
HBA: External Adapter,
KIT,CRD,CTL,HBA,12GBPS-SAS
2,5,3,4 4
Removing the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. If installed, remove the rear drive cage.
5. Disconnect any cables connected to the expansion card.
6. If installed, remove the PCIe filler bracket.
Steps
For riser 2, holding the blue touch points, lift the expansion card riser from the system.
Figure 66. Removing the riser 2
a. For the riser 1A, loosen the captive screw and then holding the blue touch points lift the riser from the system.
74
Installing and removing system components