Figure 122. Removing the power interposer board
Next steps
1. Replace the power interposer board.
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the power supply units.
4. Remove the air shroud.
Steps
1. Align the slots on the power interposer board (PIB) with the hooks on the PSU cage and press the PIB until the blue
retention tab clicks into place.
2. Using a Phillips #2 screwdriver, replace the screw that secures the PIB to the chassis.
3. Connect the cables to the system board and the drive backplane.
NOTE: Route the cables properly when you replace the PIB to prevent the cable from being pinched or crimped.
116 Installing and removing system components
To Next Page
Loading...
