Dell PowerEdge R7515 MY077 - System battery; Replacing the system battery

Figure 109. Installing the PERC card
Next steps
1. Install the air shroud.
2. If removed, replace the expansion card riser.
3. If removed, replace the rear drive cage.
4. Install the PERC card air shroud.
5. Follow the procedure listed in After working inside your system.
System battery
Replacing the system battery
Prerequisites
NOTE:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same
or equivalent type that is recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Locate the battery socket. For more information, see the System board jumpers and connectors section.
Steps
1. Use a plastic scribe and Press the release latch until the battery pops out.
NOTE: Ensure that the + side of the battery is facing upwards.
Installing and removing system components 105